I have an A95X Max which I have been using with a Toshiba 750GB HDD without any serious issues. It is formatted GUID/exFAT.
I decided to replace it with an SSD fro a number of reasons:
1) Increase capacity
2) Reduce noise
3) The HDD gets hot
I purchased a Crucial MX500 1TB SSD and formatted it with a Mac to the same as the 750GB HDD, i.e. GUID/exFAT. I copied everything from the HDD and then installed it in the A95X Max but it wasn't recognised.
I checked it on my Mac and it was fine, checked the formatting in case I had made a mistake but all was fine. I then tried connecting it using a USB/SATA cable and it worked fine. I then spent hours reformatting it with different formats, exFAT, FAT32, NTFS and different partition maps (GUID, MBR). I then tried using Windows to reformat the SSD and finally Command Line. Nothing worked.
In an answer to a customer on Amazon, Crucial stated specifically that the 1TB MX500 was compatible with the A95X Max.
I then went through a lot of Mac drive juggling to try the 960GB SanDisk from one of my MacBook Pros and then went through the same formatting but again, it would not work.
I concluded that maybe the A95X Max is not compatible with SSDs so thought I'd just increase the capacity by clearing a Toshiba 1TB HDD but that didn't work either. I looked at the disk info of the 1TB and 750GB HDDs side by side and apart from the capacity, they were identical.
I put the 750GB HDD back just to make sure that still worked and it is fine.
So, I don't understand the problem unless there is a capacity limit somewhere between 750GB and 960GB.
Can anybody offer any advice, please?
I decided to replace it with an SSD fro a number of reasons:
1) Increase capacity
2) Reduce noise
3) The HDD gets hot
I purchased a Crucial MX500 1TB SSD and formatted it with a Mac to the same as the 750GB HDD, i.e. GUID/exFAT. I copied everything from the HDD and then installed it in the A95X Max but it wasn't recognised.
I checked it on my Mac and it was fine, checked the formatting in case I had made a mistake but all was fine. I then tried connecting it using a USB/SATA cable and it worked fine. I then spent hours reformatting it with different formats, exFAT, FAT32, NTFS and different partition maps (GUID, MBR). I then tried using Windows to reformat the SSD and finally Command Line. Nothing worked.
In an answer to a customer on Amazon, Crucial stated specifically that the 1TB MX500 was compatible with the A95X Max.
I then went through a lot of Mac drive juggling to try the 960GB SanDisk from one of my MacBook Pros and then went through the same formatting but again, it would not work.
I concluded that maybe the A95X Max is not compatible with SSDs so thought I'd just increase the capacity by clearing a Toshiba 1TB HDD but that didn't work either. I looked at the disk info of the 1TB and 750GB HDDs side by side and apart from the capacity, they were identical.
I put the 750GB HDD back just to make sure that still worked and it is fine.
So, I don't understand the problem unless there is a capacity limit somewhere between 750GB and 960GB.
Can anybody offer any advice, please?